LM35 TEMPERATURE SENSOR INTERFACING WITH 8051 PDF

May 15 2019
admin

The project is built to demonstrate working of LM35 temperature sensor interfaced with through ADC The LM35 series are precision. LM35 is a 3 pin temperature sensor, which is pretty accurate in detecting Interfacing LCD in Temperature Indicator using and LM SENSOR INTERFACING: Temperature Sensor (LM35) INTERFACING with PIC18F Aditi Nandi-vtu, Leya Gopal,-vtu, Degala Vani-vtu

Author: Nikojar Shaktilabar
Country: Estonia
Language: English (Spanish)
Genre: Literature
Published (Last): 25 October 2008
Pages: 16
PDF File Size: 10.66 Mb
ePub File Size: 19.57 Mb
ISBN: 274-3-17838-824-7
Downloads: 44602
Price: Free* [*Free Regsitration Required]
Uploader: Makree

AD and display the result of a temperature on LCD. Low cost is assured by trimming and calibration at the wafer level. Then this temperature is converted into ascii form which is suitable for displaying. Keep up the good work! The full 8 bits interracing resolution are therefore applied over this reduced analog input voltage range.

Programs will not run without proper configuration byte programming. Log In Sign Up. Interfacing LCD with 8-Bit. The table below shows the comparison of family members. Voltage the answer will be of a 2. Interfacing Keypad with That means if output is mV then the temperature is 30 degrees.

This process is repeated after specified interval. There are two very important registers inside the LCD. See Connection Diagram below:. Proteus simulation also gives the same result-glowing LCD but no display of characters.

If yes then try a basic blink program on your hardware and check if that interfacingg working properly. But the user must ensure they are programmed to the chip.

C Serial Port Example. After a specified time delay, next cycle starts. What is the problem? For example, a printer typically connects to a computer via a USB interface. High to low pulse is applied on enable E pin to start data write operation.

SENSOR INTERFACING with | Guduru Vijayalakshmi –

In LM35 Temperature sensor are precision integrated-circuit sensors whose output is linearly proportional to the Centigrade Temperature, the output voltage is 10mV per degree centigrade.

Finally the complete working process, its characteristics, applications will be discussed in this paper.

LM35 gives analog reading and microcontroller interfacig digital data so we have to use a midway converter from Analog to Digital i. Done a gud job ,it’s really superb. Ball on Plate control.

8051 – ADC0804 Interfacing

Thanks and more power. It is pin number 2 on the 40 pin package. The conversion involves quantization of the input, so it necessarily introduces a small amount of error. Force the cursor to beginning of 1 st line.

High to low pulse is applied on enable E pin to start command write operation. Hey Really well written and described. An example of the use of an adjusted reference voltage is to accommodate a reduced span—or dynamic voltage range of the analog input voltage.

Command register is used to send commands such as clear display, cursor at home etc.

The LM35 comes already calibrated hence requires no external calibration. LM35 sensor produces voltage corresponding to temperature. If the analog input voltage were to range interffacing 0.